Four precautions for laser cutting machine

These matters must be paid attention to when operating the laser cutting machine

The machine tool must be strictly grounded. Only when the laser cutting machine is grounded can the energy and efficiency of the laser cutting machine be better utilized.

1.It can ensure the normal operation of the laser power supply,

2.Can extend the life of the laser tube,

3.It can prevent external interference from causing the machine to jump,

4.Prevent accidental circuit damage caused by high voltage discharge

     Try to avoid booting in thunder and lightning weather. Thunderstorm weather is often accompanied by thunder or strong current weather, so in this case, you should avoid turning on the machine, because the strong current may stop laser cutting at any time and damage its components.

     It is strictly forbidden to block the cooling water pipe. Because the laser is turned on to emit a lot of heat, and once the cooling system stops working, it is equivalent to installing a time bomb, and danger will occur at any time.

     Be careful not to run the laser at full power for a long time.